Reset Canon i6100
(1) Turn off the printer.
(2) Press and hold the RESUME button, then press and hold the
POWER button.
(3) Release the RESUME button, Next press and release the
RESUME button two(2) more times in succession, then release
the POWER button. The printer's carriage will “reset" or move
momentarily.
If the above was properly performed the printer will enter the
"Service Mode".
(4) Press the RESUME button 4 times, this will select the
clear waste ink counter function. The lamp will alternate
(change) color with each key press.
1. Service/Factory test printout, including ink sensor check.
2. EEPROM - Info printout.
3. EEPROM – Initialization.
4. Reset the Waste ink counter.
5. Printer model setting. (More selections beyond this point –
However it is best leave them unaltered – You have been
warned!)
After selecting the desired mode (eg 4), press the POWER
button to "set" the change, and return to the top of the
function selection menu. Press the POWER button again to
restart the printer.
1. Kalau sudah
diunzip jalankan GeneralTool.exe untuk ip1600
2. Pilih USB port printer
3. Centang EEPROM CLEAR
4. Klik LOCK RELEASE maka pilihan di SET DESTINATION akan
tampil
5. Klik pilihan iP2200E (jangan yang lain!)
6. Supaya yakin printer kita dikenali sbg iP1700, maka klik
DEVICE ID (akan tampil status printer di kotak besar di
sampingnya)
7. Kalau sudah, klik MAIN dan PLATEN di pilihan CLEAR WASTE
INK COUNTER (printer akan berkedip sebentar)
8. Siapkan kertas kosong untuk ngeprint, lalu klik tombol TEST
PATTERN 1
